banner



How Do I Clean The Head Of My Bissel Pro Pet Carpet Cleaner

Unplug the machine before standing

  • Check for obstructions in the castor area - clothing, rug, string, etc.
  • Remove whatsoever obstructions
  • While the auto is upright, unplug the automobile and remove both tanks
  • Remove the nozzle and brush chamber comprehend

  • Press the recline pedal and lay the car on its back

I

  • Check for broken belts
    • Use a flathead screwdriver and printing information technology into the slot at the dorsum and so front of the belt access door
    • Lift to remove the belt admission door

  • Then, remove the bike by the belts
  • Plow the auto on its side and employ a Philips screwdriver to remove the screw just underneath the wheel

  • Slide the cycle down to remove
  • Lay the motorcar dorsum downwardly on its back
  • Utilize a Phillips-head screwdriver to remove the screw on the brush scroll finish cap

  • If the gear belt is broken, gently remove information technology
  • If you are replacing your brush rolls, gently remove the chugalug

  • There are washer at the ends of the brush rolls, be careful that these do non fall off or get lost
  • To replace brush rolls, remove them from the metal posts and replace
  • Make sure the metal post goes completely through the stop of the brush roll
  • The brush roll beard should be aligned in a 'V' pattern
  • Align castor rolls with chugalug at other end
  • To ensure alignment, hold the terminate of one brush roll and twist
  • The other brush roll rotates with it
  • Check that washers are in identify
  • Reassemble the belt and cease cap, securing with screws you lot removed

  • If the flat belt is broken, gently remove the chugalug
  • If it needs replacing for any reason, the gear belt should already be removed before removing the apartment chugalug
  • Rotate the machine dorsum to its side
  • Feed the new flat belt through the opening so that it wraps around the red pulley

  • Keep it wrapped on the cerise pulley and adjust the motorcar so information technology is laying on its back again
  • Use your pollex to stretch the flat belt back to wrap around the metal axle

  • Re-secure the wheel and belt access door
  • Slide the wheel up back into the slot and secure with the spiral that was removed

  • Snap the belt access door back down into place

  • Supercede the brush cover and front nozzle to test

Source: https://support.bissell.com/app/answers/detail/a_id/1039/~/my-proheat-2x%E2%AE-revolution%E2%AE-pet-pro-carpet-cleaner-brush-is-not-turning-%7C-support

Posted by: clementsresem1938.blogspot.com

0 Response to "How Do I Clean The Head Of My Bissel Pro Pet Carpet Cleaner"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel